1.11 serial port input, 1 serial port loop out, multiple units can be cascaded,8aRS232serial port+4aRS485Serial output, each output port can be set with baud rate and other parameters, with control protocol, data output port can be specified
2.Input data can be assigned to any output or multiple simultaneous outputs in the serial port;
3.RS232andRS485The baud rate, check bit, and stop bit of the output port can be independently set;
4.Multiple devices can be cascaded, and the maximum number of cascading is255Taiwan, that isRS232Serial port can be extended to2040Output,RS485Serial port can be extended to1020Output, infrared output can be expanded to4080output;
5.The expansion does not hinder the original central controlRS232Continued use of the port;
6.Through the panel indicator lights, you can clearly observe the working status of the machine;
7.Advanced multi-threaded software technology, achievable between multiple protocols0Input at time intervals, performance exceeds similar products;
8.The setting parameter protocol and the forwarding protocol are separated, making it easier to use, because the connected device will not change frequently, and there is no need to change the serial port parameters during use, just send data.
9.LANOptional network control,TCPServer, port10000， default192.168.1.68 You can use the central control to search for changes in the host software.
10.Wiring method: infrared serial port extenderINInterface and computerRS232or central control hostRS232Connect with straight wires (2-2,3-3,5-5)，COM1-COM8forRS32data output port(whereinCOM1-COM4forDB9Joints,3To send feet,5forGND，COM5-COM8Connecting for Phoenix), infrared andRS485Interfaces are shared and can be used at the same time.
11.INInput port:1bit start,8bit data bit,1Bit stop bit, no check, baud rate is9600Bps。
12.nativeIDNo.: can be set to01-FF，FFto broadcastIDNo., that is, all machines have twoIDNumber, one is set by you, the other isFF。
13.About bit selection port: One byte has8Bit,1-8Bit represents port1-8Whether to select, this bit is1When, means selected, is0When, it means that it is not selected. For example, from8If all ports output data, the port isFF(binary1111 1111); for example, to select a port1,5,7Output data, the port is51(binary0101 0001)。
14.About serial port setting parameters:00is the baud rate300，01is the baud rate600，02is the baud rate1200，03is the baud rate2400，04is the baud rate4800，05is the baud rate9600，06is the baud rate19200，07is the baud rate38400，08is the baud rate43000，09is the baud rate56000，0Ais the baud rate57600，0Bis the baud rate115200 ;00--No verification,01--Odd check,02--even parity ;01--Stop bit is1，02--Stop bit is2。
15.Protocol format: Initiator (8A A8）+category+ID+output port+data+Terminator (8B B8）。
